1. |
Turn the ignition key to the "ON" position.
|
2. |
Cover the front sensor to stop functioning.
|
3. |
Shine a light at the rear sensor.
|
4. |
The ECM should be darkened as soon as the rear sensor detects
the light.
|
5. |
When the reverse gear is engaged, the ECM should not be darkened.
|
6. |
When heading lights to both the front and rear sensors, the ECM
should not be darkened.
|
Removal
1.
Separate the push rod (C) after remove the pin (A) and washer
(B).
2.
Remove the battery.
(Refer to Engine Electrical S ...
Temperature Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the t ...
Camshaft Position Sensor (CMPS) Circuit Diagram
(M/T)
(A/T)
...