1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
|
3. |
Disconnect the sunroof motor (A) connector.
|
4. |
Ground the terminals as below table, and check that the sunroof
unit operates.
|
5. |
Make these input tests at the connector. If any test indicates
a problem, find and correct the cause, then recheck the system. If all
the input tests prove OK, the sunroof motor must be faulty; replace
it.
|
Heater & A/C Control Unit (DATC) Self Diagnosis
1.
Self-diagnosis process
2.
How to read self-diagnostic code
After the display panel blinks three times every 0.5 second, the
...
Description
•
Component location : Ignition
lock switch is connected to clutch pedal assembly.
•
Function
1.
Start is po ...
Photo Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from
the center of the defros ...