1. |
Disconnect the negative(-) battery terminal.
|
2. |
Carefully remove the lamp lens (A) from the room lamp with a flat-tip
screwdriver.
|
3. |
Replace the bulbs (A) and remove the screws if it is necessary.
|
4. |
Remove the room lamp assembly (A) after disconnecting the connector.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the vanity lamp (A) using a screwdriver or remover and
then disconnect the connector (B).
|
Front Disc Brake
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
On-vehicle Inspection
Inspect ignition coil assembly and
Perform spark test
1.
Check for DTCs.
...
Installation
WCS(Weight Classification System) is utilizing a robust weight
measuring technology. Thus, if any of the following condi ...