1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear combination lamp cover (A).
|
3. |
Remove the mounting nuts (4EA).
|
4. |
Remove the rear combination lamp (B) after disconnecting the connector
(A).
|
5. |
Replace turn signal lamp (A) and stop/tail lamp (B) by turning
the sockets counterclockwise.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the trunk trim.
(Refer to Body - "Trunk Trim")
|
3. |
Remove the rear lamp assembly after removing the nuts (3EA) and
connector (A).
|
4. |
Replace the backup lamp (A) and stop lamp (B) by turning the sockets
counterclockwise.
[General Type]
[LED Type]
|
Side Impact Sensor (SIS)
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
Starter Removal
1.
Disconnect the battery negative (-) cable.
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - &qu ...
Oil Pan Removal
1.
Remove the under covers.
2.
Drain engine oil.
3.
Remove the oil pan (A).
(1)
...