Kia Forte: Auto Light Sensor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the auto light sensor (A) from crash pad upper side by
using screw (-) driver.
|
| 3. |
Remove the auto light connector (B).
|
Auto Light Sensor Inspection
In the state of IGN1 ON, when multifunction switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor' ...
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
See also:
Rear Door Window Glass Replacement
(4Door, 5Door)
1.
Pull down rear door window glass by pressing the power window
glass switch.
2.
Remove the rear door trim.
...
Parking Brake Lever Adjustment
Parking Brake Lever Stroke Adjustment
1.
Remove the floor console.
(Refer to Body group - "Floor console")
2.
Apply the b ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Copyright © www.kifomanual.com 2014-2024