1. |
Suspension angle change resulted from vehicle's load change.
|
2. |
Sensor angle change.
|
3. |
Microprocessor calculates necessary head lamp angle change amount.
|
4. |
Sending a proper signal to head lamp leveling device and driving
actuator.
|
1. |
Ignition on
|
2. |
Low beam on
|
3. |
On stop : If sensor lever change is 0.7° and above, head lamp
is operated after max. 1.5 sec.
|
4. |
On driving : If vehicle velocity is over 4km/h(2.48mile/h), velocity
change is not over 0.8-1.6km/h(0.5 ~ 1.0mile/h) per second, and loading
condition is changed, then head lamp is operated.
|
1. |
Auto head lamp leveling unit
1. Leveling unit & sensor
2. Sensor mounting bracket
3. Sensor linkage
|
2. |
Actuator
|
Output Speed Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
Description
System Outline
An optimal seat position set by a driver can be memorized in Power seat
unit by IMS SW, which enables restoration of seat position set by the driver
despite.
P ...
Master Cylinder
Components
1. Reservoir cap
2. Reservoir
3. Grommet
4. Master cylinder
...