Kia Forte: Parking Assist Sensor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Parking Assist System / Parking Assist Sensor Removal
[Front Bumper]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Disconnect the connector (A) from the ultrasonic sensor.
|
| 4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
|
[Rear Bumper]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
| 3. |
Disconnect the connector (A) from the ultrasonic sensor.
|
| 4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
|
Parking Assist Sensor Installation
1.
Install the ultrasonic sensor after connecting the connector.
2.
Install the front/rear bumper.
3.
Connect t ...
See also:
Spark Plug Cleaning
The combustion temporarily becomes unstable, due to the aged fuel and
the carbon deposits accumulated on the spark plug(s) after long-term storage.
[1st Method]
1.
...
Variable Charge Motion Actuator (VCMA) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the VCMA connector.
3.
Check that the VCMA is not stuck by foreign ...
Intake Air Temperature Sensor (IATS) Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute
Pressure Sensor and detects the intake air temperature.
To calculate precise air quantity, correction of the air tem ...
Copyright © www.kifomanual.com 2014-2024