1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Low Panal")
|
3. |
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
|
4. |
Remove the wiper switch.
(Refer to "Multifunction switch")
|
5. |
Remove the ignition switch after disconnecting the ignition switch
6P connector.
|
6. |
Remove the key warning/immobilizer connector (A).
|
7. |
After loosening the screw, remove the key warning switch and key
Illumination (B).
|
8. |
Pushing lock pin with key ACC.
|
9. |
Remove the key lock cylinder (A).
|
Output Speed Sensor Installation
1.
Install in the reverse order of removal.
After replacement or reinstal ...
SS-A Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B)
▷ Control type : Normal low type
Control pressure kpa (kgf/cm², psi)
490.33(5.0, 71.12)
Internal resistance(Ω ...
Control Cable Inspection
1.
Check the select cable for proper operation and for damage.
2.
Check the shift cable for proper operation and for damage.
...