1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
|
3. |
Remove the cluster fascia panel.
(Refer to Body - "Cluster Fascia Panel")
|
4. |
After loosening the mounting screws, remove the drive airvent
duct assembly (A).
|
5. |
After loosening the mounting screws, remove the clock fascia panel
(A).
|
6. |
Disconnect the clock switch connector (A).
|
7. |
After loosening the mounting screws, then remove the center airvent
duct assembly [RH] (A).
|
8. |
Remove the in-car hose (A).
|
9. |
Disconnect the in-car sensor connector (B).
|
10. |
Loosen the mounting screws and then remove the in-car sensor (A)
located in the back side of the center airvent duct assembly [RH].
|
11. |
Install in the reverse order of removal.
|
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the blower resistor connector (A) and then remove the
blower resistor (B) af ...
Heated Oxygen Sensor (HO2S) Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed
both upstream and downstream of the Catalytic Converter. It varies in accordance
with the air/fuel ratio.
Th ...
Canister Installation
1.
Installation is the reverse of removal.
Canister installation bolt/nut:
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...