Kia Forte: Mode Control Actuator Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Mode Control Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body -"Crash Pad Lower Panel")
|
| 3. |
Remove the driver's side shower duct by loosening the screw.
|
| 4. |
Disconnect the connector (A) and then remove the mode control
actuator (B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Auto Defogging Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defoggin ...
See also:
Description
Burglar Alarm State [B/A State]
B/A State
Description
DISARM
1.
In "DISARM" state, no vehicle start inhibition. So, whe ...
Adjustment
(4Door, 2Door)
1.
After loosening the trunk lid hinge (A) mounting bolt, adjust
the trunk lid by moving it up or down, or right or left.
2 ...
Component
1. Concentric slave cylinder assembly
2. Manual transaxle
...
Copyright © www.kifomanual.com 2014-2024