Kia Forte: Power Mosfet Replacement
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Power Mosfet Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the power mosfet connector (A) and then remove the
power mosfet (B) after loosening the mounting screws.
|
| 3. |
Install in the reverse order of removal.
|
Power Mosfet Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
the blower motor.
3. ...
Blower Resistor Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
See also:
Heater Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/ recycling/ charging station.
...
Components
Components (1)
(Rear Seat 5:5 Type)
[Rear Seat Back]
1. Rear seat headrest
2. Rear seat back webbing guide
3. Rear seat headrest guide
4. Rear seat back ...
Manifold Absolute Pressure Sensor (MAPS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Conditio ...
Copyright © www.kifomanual.com 2014-2024