Kia Forte: Blower Resistor Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Resistor Inspection
| 1. |
Measure terminal-to-terminal resistance of the blower resistor.
|
| 2. |
If the measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Power Mosfet Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the power mosfet connector (A) and then remove the
power mosfet (B) after lo ...
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the blower resistor connector (A) and then remove the
blower resistor (B) af ...
See also:
Auto Defogging Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defoggin ...
Components
(4Door, 5Door)
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Rear pillar trim
5. Rear wheel house trim
6. Cowl side trim
...
Copyright © www.kifomanual.com 2014-2024