1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the intake actuator connector.
|
3. |
Verify that the intake actuator operates to the recirculation
position when connecting 12V to terminal 3 and grounding terminal 7.
|
4. |
Connect the intake actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 6 and 7.
Specification
|
7. |
If the intake actuator dones not operate well, substitute with
a known-good intake actuator and check for proper operation.
|
8. |
Replace the intake actuator if it is proved that there is a problem
with it.
|
Shift Lever Components
1. Shift lever knob
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...
Rear Bumper Beam Assembly Component Location
(4Door, 2Door)
1. Rear bumper beam assembly
(5Door)
1. Rear bumper beam assembly
...
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross V ...