Connector Pin Function |
Connector |
No. |
Description |
Connector |
No. |
Description |
A |
1 |
Ground |
B |
14 |
Intake actuator (Recirculation) |
2 |
Middle - High |
15 |
Sensor signal |
||
3 |
Middle - Low |
16 |
Ground |
||
4 |
High |
17 |
Illumination (+) (Tail) |
||
5 |
Common |
18 |
Sensor REF (+5V) |
||
6 |
Low |
19 |
Detent OUT (+) |
||
B |
1 |
Battery (+) |
20 |
Max blower ON signal |
|
2 |
IGN 2 |
21 |
Evaporator temperature sensor (+) |
||
3 |
IGN 1 |
22 |
Ambient temperature sensor (+) |
||
4 |
HTD |
23 |
PTC relay (PTC only) |
||
5 |
Rear defog switch |
24 |
ECV (+) (ECV only) |
||
6 |
Mode actuator feedback |
25 |
ECV (-) - ground (ECV only) |
||
7 |
Temperature control actuator feedback |
26 |
- |
||
8 |
Intake actuator feedback |
27 |
C_CAN (High) |
||
9 |
Mode control actuator (Vent) |
28 |
C_CAN (Low) |
||
10 |
Mode control actuator (Defrost) |
29 |
- |
||
11 |
Temperature control actuator (Cool) |
30 |
Blower ON signal to common |
||
12 |
Temperature control actuator (Warm) |
31 |
Ground |
||
13 |
Intake actuator (Fresh) |
32 |
Illumination (-) (Rheostat) |
System operation
Ventilation
1. Set the mode to the
position.
2. Set the air intake control to the outside (fresh) air position.
3. Set the temperature control to the desired position.
4. Set the fan speed ...
Front Seat Frame Assembly Replacement
•
Put on gloves to protect your hands.
&nb ...
Blower Resistor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the blower resistor connector (A) and then remove the
blower resistor (B) af ...