Connector Pin Function |
Connector |
No. |
Description |
Connector |
No. |
Description |
A |
1 |
Illumination (+) (Tail) |
A |
25 |
Humidity (PVM) |
2 |
Sensor REF (+5V) |
26 |
Ambient sensor (+) |
||
3 |
Defog actuator (Open) |
27 |
In-car sensor (+) |
||
4 |
Defog actuator (Close) |
28 |
Evaporator sensor (+) |
||
5 |
Mode actuator (Vent) |
29 |
ECV (+) |
||
6 |
Mode actuator (Defrost) |
30 |
ECV (-) |
||
7 |
Mode actuator feedback |
31 |
Photo sensor (-) - Left |
||
8 |
Intake actuator (Fresh) |
32 |
Photo sensor (-) - Right |
||
9 |
Intake actuator (Recirculation) |
33 |
HTD |
||
10 |
Intake actuator feedback |
34 |
Rear defog switch |
||
11 |
Temperature actuator (Cool) - Driver |
35 |
K-Line |
||
12 |
Temperature actuator (Warm) - Driver |
36 |
PTC relay (Gasoline PTC only) |
||
13 |
Temperature actuator feedback - Driver |
37 |
- |
||
14 |
Temperature actuator (Cool) - Passenger |
38 |
ISG DC |
||
15 |
Temperature actuator (Warm) - Passenger |
39 |
- |
||
16 |
Temperature actuator feedback - Passenger |
40 |
Sensor ground |
||
17 |
C_CAN (High) |
B |
1 |
Ground |
|
18 |
C_CAN (Low) |
2 |
IGN 2 |
||
19 |
Detent OUT (+) |
3 |
Blower motor (+) |
||
20 |
Illumination (-) (Rheostat) |
4 |
Ground |
||
21 |
Ion signal |
5 |
FET (Gate) |
||
22 |
Clean signal |
6 |
FET (Drain feedback) |
||
23 |
Ionizer diagnosis |
7 |
IGN 1 |
||
24 |
Defog actuator feedback |
8 |
Battery (+) |
Record your key number
The key code number is stamped on the key code tag attached to the key set. Should
you lose your keys, this number will enable an authorized Kia dealer to duplicate
the keys easily. Remove the k ...
Mode Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body -"Crash Pad Lower Panel") ...
Fuel requirements
Your new Kia vehicle is designed to use only unleaded fuel having a pump octane
number ((R+M)/2) of 87 (Research Octane Number 91) or higher.
Your new vehicle is designed to obtain maximum performan ...