When heavy rear components such as suspension, fuel tank, spare tire,
tailgate and trunk lid are to be removed, place additional weight in
the luggage area before hoisting. When substantial weight is removed
from the rear of the vehicle, the center of gravity may change and can
cause the vehicle to tip forward on the hoist.
|
|
1. |
Place the lift blocks under the support points as shown in the illustration.
|
2. |
Raise the hoist a few inches (centimeters) and rock the vehicle to be
sure it is firmly supported.
|
3. |
Raise the hoist to full height to inspect the lift points for secure
support.
|
DC/DC Converter Operation Principle
•
In the ISG mode, if the power of an audio system turns
OFF by drawdown while “Auto ...
Starting the engine
WARNING - Proper footwear
Always wear appropriate shoes when operating your vehicle. Unsuitable shoes
(high heels, ski boots, sandals, etc.) may interfere with your ability to use the
brake and acc ...
Heater & A/C Control Unit (DATC) Replacement
1.
Remove the audio unit.
(Refer to Body Electrical System - "Audio Unit")
2.
After loosening the mounting screws, remove the ...