1. |
Check belt for maintenance and abnormal wear of V-ribbed part.
Replace if necessary.
|
2. |
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
|
Belt tension measurement |
Belt tension
New belt:
637.4 ~ 735.5 N (65 ~ 75 kgf, 143.3 ~ 165.3 lbf)
Used belt:
441.3 ~ 539.4 N (45 ~ 55 kgf, 99.2 ~ 121.3 lbf)
|
|
Using a mechanical tension gauge |
1. |
While pressing the handle (A) of the gauge, insert the belt (B)
between pulley and pulley (or idler) into the gap between spindle (C)
and hook (D).
|
2. |
After releasing the handle (A), read a value on the dial pointed
by the indicator (B).
|
Using a sonic tension meter |
1. |
Input the belt specifications into the tension meter (A).
|
2. |
Locate the micro phone (B) close to the center of belt span (A)
and bounce the belt by finger 2~3 times. Read a value on the display.
[With A/C]
[Without A/C]
|
If adjustment is necessary: |
1. |
Loosen the mounting bolts (A).
|
2. |
Tighten the adjusting bolt (B) counterclockwise in loose tension;
fasten the bolt clockwise in high tension.
|
3. |
Recheck tension of the belt.
|
4. |
After adjusting tension, tighten the mounting bolts.
|
Front Stabilizer Bar Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the front stabilizer bar for deformation.
...
Seat Heater (Air Ventilation) Circuit Diagram
...
Dynamic Damper Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...