1. |
Check that the TDC marks on the intake and exhaust CVVT sprockets
are slightly turned (about 2 to 3 teeth) from the TDC position after
the timing chain has been removed.
|
2. |
Turn the crankshaft about 2 to 3 teeth clockwise from the TDC
position (approx. 3° clockwise from the engine vertical line), by the
same amount of rotation as the intake CVVT sprocket from the TDC position.
|
3. |
Install the timing chain guide (A).
|
4. |
Install the timing chain tensioner arm (A).
|
5. |
Install the timing chain.
Crankshaft sprocket → Timing chain guide → Intake CVVT sprocket
→ Exhaust CVVT sprocket
|
6. |
Install the timing chain auto tensioner (A) and remove the stopper
pin (B).
|
7. |
After rotating crankshaft 2 revolutions in regular direction (clockwise
viewed from front), confirm that the TDC marks on the intake and exhaust
CVVT sprockets are aligned with the top surface of cylinder head.
|
8. |
Install the other parts in reverse order of removal.
|
|
Tightening Torques
Items
N.m
kgf.m
lb-ft
Oil drain plug
58.9 ~ 78.5
6.0 ~ 8.0
43.4 ~ 57.8
Oil filler plug
58.9 ~ 78.5
6.0 ~ 8.0
...
Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Ignition Coil Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connec ...