1. |
Remove the radiator cap, wet its seal with engine coolant, and
then install it on a pressure tester.
|
2. |
Apply a pressure of 93.16 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cm², 13.51
~ 17.78 psi).
|
3. |
Check for a drop in pressure.
|
4. |
If the pressure drops, replace the cap.
|
1. |
Wait until engine is cool, then carefully remove the radiator
cap and fill the radiator with engine coolant, then install it on the
pressure tester.
|
2. |
Apply a pressure tester to the radiator and apply a pressure of
93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm², 13.51 ~ 17.78psi).
|
3. |
Inspect for engine coolant leaks and a drop in pressure.
|
4. |
Remove the tester and reinstall the radiator cap.
|
ECM Terminal And Input/Output signal (A/T)
ECM Terminal Function
Connector [CNG-AA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
Ignition Co ...
TJ Joint Replacement
•
Special grease must be applied to the driveshaft joint.
Do not substitute with another ...
Auto Light Sensor Inspection
In the state of IGN1 ON, when multifunction switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor' ...