Kia Forte: Water pump Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Water pump Inspection
| 1. |
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
|
| 2. |
Check the bearing for damage, abnormal noise and sluggish rotation,
and replace the coolant pump assembly if necessary.
|
| 3. |
Check for coolant leakage. If coolant leaks from hole, the seal
is defective. Replace the coolant pump assembly.
|
Water pump Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant. Remove
the radiator cap to help drain the coolant faster.
2.
Remove the drive ...
Water pump Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the bleed hole of the water pump
Visually c ...
See also:
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Instrument panel overview
1. Instrument cluster
2. Lighting control lever
3. Audio remote control buttons
4. Horn
5. Driver's front air bag
6. Cruise control button
7. Wiper and washer control lever
8. Ignition ...
Multimedia Jack Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly&quo ...
Copyright © www.kifomanual.com 2014-2024