1. |
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
|
2. |
Check the engine oil level.
After engine warm up stop the engine wait 5 minutes then check
the oil level. Oil level should be between the "L" and "F" marks on
the dipstick. If low check for leakage and add oil up to the "F" mark.
|
For best performance and maximum protection of all types of operation,
select only those lubricants which:
|
Schematic Diagram
Canister
The Canister is filled with charcoal and absorbs evaporated fuel vapor
from the fuel tank. The gathered fuel vapor in canister is drawn into the intake
manifold by the ECM/PC ...
Installation
•
If the oil seal on the transaxle case side is damaged
and fluid is leaking, replace th ...
Heated Oxygen Sensor (HO2S) Removal
[SULEV]
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the connector (A), and th ...