Kia Forte: Oil Pressure Switch Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Inspection
| 1. |
Check the continuity between the terminal and the body with an
ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when the
fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 50 kPa (0.50 kgf/cm², 7.25 psi)
is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken.
Replace it.
|
Oil Pressure Switch Removal and Installation
1.
Disconnect the oil pressure switch connector (A) and then remove
the oil pressure switch (B).
Tightening torque :
9.8 ~ 11.8N.m (1 ...
Oil Level Gauge & Pipe Removal and Installation
1.
Remove the oil level gauge (A).
2.
Install in the reverse order of removal.
...
See also:
Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which seals the fuel filler. After the gasket
on the fuel filler cap and the filler ...
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Component Location
1. Horn switch
2. Horn relay (Engine room compartment)
3. Clock spring
4. Horn
...
Copyright © www.kifomanual.com 2014-2024