1. |
Check for resistance between terminals in each switch position.
|
1. |
Connect the cruise control switch connector to the control switch.
|
2. |
Measure voltage between terminals on the harness side connector
when each function switch is ON (switch is depressed).
|
3. |
If not within specification, inspect the control switch resistance.
The measuring resistance value is not within specification, replace
the switch and measure the voltage again.
|
4. |
If resistance is OK but, measuring voltage is not within specification,
inspect the wiring harness and connectors between the switch and the
ECM.
|
Disaseembly
1.
Loosen the screw (A-3ea) and then remove the lower cover (B) from
the steering wheel body.
Tightening torque :
7.8 ~ 11.8 N.m(0.8 ...
Yaw-rate and Lateral G Sensor
When the vehicle is turning with respect to a vertical axis the yaw rate
sensor detects the yaw rate electronically by the vibration change of plate
fork inside the yaw rate sensor.
If ya ...
Tail Gate Latch Component Location
(5Door)
1. Tail gate latch assembly
...