When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer System")
|
When replacing the ECM, the vehicle equipped with the smart key
system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the ECM learns the smart key information
automatically.
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the ECM Connector (A).
|
3. |
Remove the battery. (Refer to Engine Electrical System - "Battery")
|
4. |
Remove the mounting bolts (A) and then remove the ECM (B).
|
Description
•
Component location : Clutch
switch is connected to top of the clutch pedal assembly.
•
Function
1.
Clutch ...
Rear Wheel Guard Replacement
•
Put on gloves to protect your hands.
&nb ...
Cylinder Head Cover Installation
1.
Install cylinder head cover.
(1)
The hardening sealant located on the cylinder head cover
and the gap between the timing chain co ...