Kia Forte: Engine Control Module (ECM) Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Control Module (ECM) Installation
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer System")
|
When replacing the ECM, the vehicle equipped with the smart key
system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the ECM learns the smart key information
automatically.
|
| 1. |
Install in the reverse order of removal.
|
Engine Control Module (ECM) Removal
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
See also:
Drive Belt Inspection
1.
Check belt for maintenance and abnormal wear of V-ribbed part.
Replace if necessary.
...
Brake Booster Vacuum Pressure Sensor Inspection
1.
Check installation status of BBVPS and Vacuum hose or damage of
vacuum hose.
2.
Connect GDS to DLC (Data Link Cable).
...
Turn Signal Lamp
Removal
1.
Remove the outside rear view mirror.
(Refer to Body - "Outside Rear View Mirror")
Installation
1.
Install the out ...
Copyright © www.kifomanual.com 2014-2024