Kia Forte: ETC (Electronic Throttle Control) System Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Inspection
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2
at C.T. and W.O.T.
|
|||||||||||
ETC Motor
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ETC module connector.
|
| 3. |
Measure resistance between the ETC module terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
ETC (Electronic Throttle Control) System Circuit Diagram
(M/T)
(A/T)
...
ETC (Electronic Throttle Control) System Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the resonator and the air intake hose (Refer to “I ...
See also:
IMS Power Seat Control Installation
-
Make sure that the IMS control switch connectors and related
connectors are plugged in ...
Air Ventilation Seat Unit Description
The ventilated seat system uses a Push method to cool the seat. A blower
mounted in the seat generates the cool air, which then travels through ducts
to the seat back and cushion.
...
Heater & A/C Control Unit (Manual) Components
Connector Pin Function
Connector
No.
Description
Connector
No.
Description
A
1
Ground
B
14
In ...
Copyright © www.kifomanual.com 2014-2024