Kia Forte: ETC (Electronic Throttle Control) System Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Remove the resonator and the air intake hose (Refer to “Intake
And Exhaust System” in EM group).
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (B).
|
| 5. |
Remove the installation bolts (C), and then remove the ETC module
from the engine.
|
ETC (Electronic Throttle Control) System Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
ETC (Electronic Throttle Control) System Installation
•
Install the component with the specified torques.
•
...
See also:
Operation Condition for the ISG function
1. Auto stop or Auto start condition
(If all of the below condition are satisfied)
Items
State
Remark
Driving conditions
ISG OFF Switch
...
Heater Unit Components
1. Heater Case (Left)
2. Heater Case (Right)
3. Console Separator
4. Defog Door
5. Vent Door
6. Floor Door
7. Mix Door (Manual)
8. Mix Door (DATC-Left)
9. Mix Door ( ...
Shift Lever Components
1. Shift lever knob
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...
Copyright © www.kifomanual.com 2014-2024