Kia Forte: Engine Coolant Temperature Sensor (ECTS) Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped.
|
|
| •
|
Apply the engine coolant to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
Engine coolant temperature sensor
installation:
29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the engine may stop ...
See also:
Emergency Fastening Device (EFD)
Front emergency fastening device operates as well as belt pretensioner
at the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat and ...
Crash Pad Side Cover Replacement
•
Put on gloves to protect your hands.
&n ...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...
Engine Coolant Temperature Sensor (ECTS) Removal
Crankshaft Position Sensor (CKPS) Description