Kia Forte: Camshaft Position Sensor (CMPS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Removal
|
| [Bank 1 / Intake] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (B) after removing
the clip (A).
|
| 3. |
Remove the installation bolt (C), and then remove the sensor.
|
| [Bank 1 / Exhaust] |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the camshaft position sensor connector (B) after removing
the clip (A).
|
| 3. |
Remove the installation bolt (C), and then remove the sensor.
|
Camshaft Position Sensor (CMPS) Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Camshaft Position Sensor (CMPS) Installation
•
Install the component with the specified torques.
•
...
See also:
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the e ...
Hood Insulator Pad Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator
pad (A).
...
Copyright © www.kifomanual.com 2014-2024