Kia Forte: Accelerator Position Sensor (APS) Description

Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line. The second sensor monitors the first sensor and its output voltage is half of the first one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the diagnostic system judges that it is abnormal.

Heated Oxygen Sensor (HO2S) Installation

   • Install the component with the specified torques. • ...

Accelerator Position Sensor (APS) Specification

Accelerator Position Output Voltage (V) APS1 APS2 C.T 0.7 ~ 0.8 0.29 ~ 0.46 W.O.T 3.85 ~ 4.35 1.93 ~ 2.18 ...

See also:

Inspection
1. Inspect the check valve in the vacuum hose.    Do not remove the check va ...

Lubricants
Items  Specified lubricants  Quantity Clutch release cylinder assembly Brake fluid DOT 3 or DOT 4  As required Input shaft s ...

Engine Control Module (ECM) Installation
   When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. ...