Kia Forte: Variable Intake Solenoid (VIS) Valve Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the variable intake solenoid valve connector (A).
|
| 3. |
Disconnect the vacuum hoses (B) from the valve.
|
| 4. |
Remove the installation nut, and then remove the valve from the
surge tank.
|
Variable Intake Solenoid (VIS) Valve Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...
Variable Intake Solenoid (VIS) Valve Installation
•
Install the component with the specified torques.
•
...
See also:
Removal
1.
Disconnect the brake fiuid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder rese ...
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before starting work.
The support r ...
Piston and Connecting Rod Reassembly
•
Thoroughly clean all parts to be assembled.
•
...
Copyright © www.kifomanual.com 2014-2024