Kia Forte: Variable Intake Solenoid (VIS) Valve Installation
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
•
|
Be careful of foreign material not to flow into the valve.
|
|
1. |
Install in the reverse order of removal.
Variable intake solenoid valve
bracket installtion bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the variable intake solenoid valve connector ( ...
Canister Close Valve (CCV) is normally open and is installed on the canister
ventilation line. It seals evaporative emission control system by shutting the
canister from the atmosphere during ...
See also:
Speakers Removal
Front Speaker
1.
Remove the front door trim panel and speaker connector.
(Refer to Body - "Front Door Trim")
2.
Remove the ...
Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetooth pairing (searching) mode
User’ ...
Multimedia Jack Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly&quo ...