Kia Forte: Variable Charge Motion Actuator (VCMA) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Charge Motion Actuator (VCMA) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the VCMA connector (A).
|
| 3. |
Remove the VCMA (A) after removing 3 installation bolts.
|
Variable Charge Motion Actuator (VCMA) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the VCMA connector.
3.
Check that the VCMA is not stuck by foreign ...
Variable Charge Motion Actuator (VCMA) Installation
•
Install the component with the specified torques.
•
...
See also:
IMS Power Seat Control Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
...
Front Wiper Motor Installation
1.
Install the wiper motor.
2.
Install the crank arm.
...
Rear Door Outside Handle Replacement
(4Door, 5Door)
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the rear door outside
handle cov ...
Copyright © www.kifomanual.com 2014-2024