Kia Forte: Brake Booster Vacuum Pressure Sensor Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Booster Vacuum Pressure Sensor Installation
Brake Booster Vacuum Pressure Sensor can not be replaced separately
due to vacuum leak.
Therefore, the sensor must be replaced with an assembly with the
brake booster.
(Refer to Brake System - Brake Booster)
|
Brake Booster Vacuum Pressure Sensor Removal
Brake Booster Vacuum Pressure Sensor can not be replaced separately
due to vacuum leak.
Therefore, the sensor mu ...
AGM Battery Description
AGM battery is used for especially heavy load on the vehicle network depending
on equipment and requirements. AGM stands for Absorbent Glass Material Battery;
that is absorbent glass fibre fl ...
See also:
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...
Accelerator Position Sensor (APS) Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
DC/DC Converter Removal
1.
Disconnect the battery negative (-) cable.
2.
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
...
Copyright © www.kifomanual.com 2014-2024