Kia Forte: Alternator On-vehicle Inpection - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Alternator On-vehicle Inpection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator On-vehicle Inpection

  
Check that the battery cables are connected to the correct terminals.
Disconnect the battery cables when the battery is given a quick charge.
Never disconnect the battery while the engine is running.
Check The Battery Terminals And Fuses
1.
Check that the battery terminals are not loose or corroded.
2.
Check the fuses for continuity.
Inspect Drive Belt
1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
  
Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.

Alternator Specification
Item Specification Rated voltage 13.5V, 120A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type ...

Alternator Removal
1. Disconnect the battery negative (-) cable. 2. Remove the drive belt. (Refer to Engine Mechanical System - "Timing Chain") ...

See also:

Air Cleaner Components
1. Air intake hose 2. Air cleaner cover 3. Air cleaner filter 4. Air cleaner body 5. Resonator 6. Air duct 7. Air intake shield ...

DC/DC Converter Description
Due to the considerably more frequent occurrence of starting operations, the electrical load that occurs often leads to voltage dips in the vehicle network. In order to stabilize the power s ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Copyright © www.kifomanual.com 2014-2024