Kia Forte: Alternator Removal - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Alternator Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator Removal

1.
Disconnect the battery negative (-) cable.
2.
Remove the drive belt.
(Refer to Engine Mechanical System - "Timing Chain")
3.
Disconnect the alternator connector (A) and the cable from the alternator "B" terminal (B).

Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)

4.
Remove the alternator (A) after removing the bolts.

Tightening torque :
[12 mm bolt] 21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~ 23.9 lb-ft)
[14 mm bolt] 29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)

Alternator On-vehicle Inpection
   • Check that the battery cables are connected to the correct terminals. ...

Alternator Intallation
1. Install in the reverse order of removal.    Adjust the alternator belt te ...

See also:

Front Seat Shield Inner Cover Component Location
1. Front seat shield inner cover ...

Rear Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer p ...

Rear Seat Belt Buckle Replacement
(4Door) [LH] 1. Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly") 2. Loosen ...

Copyright © www.kifomanual.com 2014-2024