1. |
Disconnect the battery negative (-) cable.
|
2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Engine And Transaxle Assembly")
|
3. |
Disconnect the starter cable (A) from the B terminal on the solenoid
then disconnect the connector (B) from the S terminal.
|
4. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
Brake Booster Vacuum Pressure Sensor Removal
Brake Booster Vacuum Pressure Sensor can not be replaced separately
due to vacuum leak.
Therefore, the sensor mu ...
Overhead Console Lamp Installation
1.
Install the overhead console lamp after connecting the sunroof
switch connector and lamp connector.
2.
Install the lens after tightening ...
Side Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front side m ...