1. |
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in and when it is released.
|
2. |
The stop lamp switch is in good condition if there is no continuity
when plunger (A) is pushed.
|
Description
•
Component location : Ignition
lock switch is connected to clutch pedal assembly.
•
Function
1.
Start is po ...
Front Body
Front Body A
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front Body B
* These dimensions indicated in th ...
Description
The ECM (Electro Chromatic inside rear view Mirror) is for dimming the
reflecting light from a vehicle behind at night, Preventing glare from the light.
The forward facing sensor detects brig ...