Kia Forte: Inspection
| 1. |
Inspect diaphragm spring wear which is in contact with a clutch
release bearing.
|
| 2. |
Check the clutch cover and disc surface for wear or cracks.
|
| 3. |
Check the clutch disc facing for slipping or oil marks.
|
| 4. |
Measure the depth from a clutch facing surface to a rivet. If
the measured value is less than the specification below, replace it.
|
Removal
1.
Remove the transaxle assembly.
(Refer to Manual Transaxle System - " Manual Transaxle")
2.
Remove the clutch cover bolts. ...
Installation
Clutch cover and disc should be replaced as a set.
1.
Apply grease on a disc spline ...
See also:
Accelerator Position Sensor (APS) Circuit Diagram
(M/T)
(A/T)
...
Components Location
1. Sub frame
2. Lower arm
3. Steering gearbox
4. Stabilizer bar
5. Front strut assembly
6. Front stabilizer link
...
Components Location
1. Automatic transaxle
2. Inhibitor switch
3. Transaxle Control Module (TCM)
4. Valve body cover
5. Solenoid valve connect
6. Oil temperature sensor
7. Valve body assembly ...
Copyright © www.kifomanual.com 2014-2024