Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Clutch Switch / Installation

1.	Install in the reverse order of removal.

2.

Adjust the clutch switch.

(1)

Adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range:

0.5 ~ 1.0 mm (0.0197 ~ 0.0394 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the smart junction box (Refer to Body Electri ...

Ignition Lock Switch

...

See also:

Crankshaft Damper Pulley Removal and Installation
1. Remove the RH front wheel. 2. Remove the drive belt. (Refer to Timing System - "Drive Belt") 3. ...

Power Seat Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Inspection
Component Inspection 1. Remove the clutch switch. (Refer to Clutch Switch - "Removal") 2. Push the clutch switch in the di ...

Categories

Copyright © www.kifomanual.com 2014-2024