1. |
Separate the push rod (C) after remove the pin (A) and washer
(B).
|
2. |
Remove the battery.
(Refer to Engine Electrical System - "Battery")
|
3. |
Remove the ECM.
(Refer to Engine Control/Fuel System - "Engine Control Module
(ECM)")
|
4. |
Disconnect the clutch regulator (B) and reservoir hose (A) from
the clutch master cylinder.
|
5. |
Remove the master cylinder (A) by rotating in a clockwise direction.
|
Heated Oxygen Sensor (HO2S) Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed
both upstream and downstream of the Catalytic Converter. It varies in accordance
with the air/fuel ratio.
Th ...
Smart Key Diagnostic Inspection
Self Diagnosis With GDS
Smart key system defects can be quickly diagnosed with the GDS. GDS operates
actuator quickly to monitor, input/output value and self diagnosis.
The following thr ...
Front Strut Assembly Components
1. Strut assembly
2. Insulator
3. Strut bearing
4. Spring upper pad
5. Coil spring
6. Dust cover
7. Spring lower pad
...