Clutch Release Cylinder Air Bleeding Procedure |
|
1. |
After disconnecting a cap from the clutch release cylinder air
bleeder, insert a vinyl hose in the plug.
|
2. |
Refill the clutch master cylinder with the specified fluid.
|
3. |
Loosening the plug screw, press and release the clutch pedal about
10 times.
|
4. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards,
raise the pedal with a hand.
|
5. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and re-tighten it with the pedal pressed. Raise it again, then.
|
6. |
Repeat the step 4 two or three times.
(until there is no bubble in the fluid)
|
7. |
Refill the clutch master cylinder with the specified fluid.
|
Fuel Line Removal
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line".)
...
Engine Cover Removal and Installation
1.
Remove the engine cover (A).
•
...
Relay Box (Passenger Compartment) Description
Smart Junction Box(SJB)
1.
General function : Interior Junction Box + some functions of BCM
It controls loads with CAN communication and IPS.
2. ...