Concentric Slave Cylinder Air Bleeding Procedure |
1. |
After disconnecting a cap from the concentric slave cylinder air
bleeder, insert a vinyl hose in the plug.
|
2. |
Refill the reservoir tank with the specified fluid.
|
3. |
Pump the clutch pedal about 10 times.
|
4. |
Loosen the air bleed screw (A) at hold down the clutch pedal to
allow air to escape from the clutch system. Then tighten the air bleed
screw.
|
5. |
Repeat the step 2 ~ 4 until there is no bubble in the fluid.
|
Rear Door Trim Replacement
(4Door, 5Door)
•
Put on gloves to protect your hands.
...
DC/DC Converter Installation
1.
Install in the reverse order of removal.
If the battery negative (-) c ...
Thermostat Components
1. Water inlet fitting
2. Thermostat
3. Bypass hose
4. Heater pipe & hose assembly
...