1. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
3. |
Set shift lever to "N" position.
|
4. |
Separate the control cable from the control shaft after remove
the pin (A) and washer (B).
|
5. |
Remove the control shaft assembly after loosen the bolts.
|
Hazard Lamp Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
...
Manifold Absolute Pressure Sensor (MAPS) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...
Components Operations
ECM (Engine Control Module)
1.
The ECM(PCM) (A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transponder
...