Kia Forte: Special Service Tools - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Special Service Tools

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Special Service Tools

Tool
(Number and Name)
Illustration
Use
09200-3N000
Engine support fixture (Beam)

Removal and installation of the transaxle.
Use this adapter (SST No. : 09200-4X000) with the supporter (SST No. : 09200-2S000).
※Permit operating with 09200-38001.
09200-2S000
Engine support fixture (Supporter)

Removal and installation of the transaxle.
Use this beam (SST No. : 09200-38001/3N000) with the supporter (SST No. : 09200-2S000) and adapter (SST No. : 09200-4X000).
09200-4X000
Engine support fixture (Adapter)

Removal and installation of the transaxle.
Use this beam (SST No. : 09200-38001/3N000) with the supporter (SST No. : 09200-2S000).
09452-26100
Oil seal installer

Installation of transaxle case oil seal.
[Using with handle (SST No.09231-H1100)]
09231-H1100
Bar

Installation of transaxle case oil seal.
[Using with oil seal installer (SST No.:09452-26100)]
09480-A3800
Inhibitor switch guide pin



※ Engine support fixture special tool assembly drawing

1. 09200-3N000(Main bar)
2. 09200-3N000(Sub bar)
3. 09200-3N000(Handle)
4. 09200-3N000(Stopper)
5. 09200-3N000(Bolt-1)
6. 09200-4X000 (Adapter)
7. 09200-2S000(Supporter)
8. 09200-2S000(Supporter)
9. 09200-3N000(Nut)
10. 09200-3N000(Snap ring)
11. 09200-3N000(Sub fixture)
12. 09200-3N000(Stopper)
13. 09200-3N000(Nut)
14. 09200-2S000(Spacer)
15. 09200-2S000(Sub fixture)
16. 09200-2S000(Nut)
17. 09200-3N000(Pin)

Lubricants
Item  Specified lubricant  Quantity Transaxle fluid ATF SP-Ⅳ or equivalent  7.3L (1.93 U.S gal.,  7.71 U.S.qt., 6.42 Imp.qt ...

Automatic Transaxle
...

See also:

Fuel Tank Air Filter Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Dis ...

Engine Coolant Temperature Sensor (ECTS) Inspection
1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS. 4. ...

Knock Sensor (KS) Description
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. Whe ...

Copyright © www.kifomanual.com 2014-2024