1. |
Turn ignition switch OFF.
|
2. |
Disconnect the Solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
(Refer to Torque Converter Control Solenoid Valve - "Specifications")
|
DC/DC Converter Installation
1.
Install in the reverse order of removal.
If the battery negative (-) c ...
Specifications
AVN Head Unit
Item
Specification
Power supply
DC 14.4V negative ground
Load Impedance
4ohm × 4
Tuning type
PLL SYNTH ...
Fuel Pressure Test
1.
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
...