1. |
Turn ignition switch OFF.
|
2. |
Disconnect the Solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
(Refer to Line Pressure Control Solenoid Valve - "Specifications")
|
Troubleshooting
Vehicle inspection
SYMPTOM CHART
Symptom
Suspect Area
Remedy (See page)
Squeak or grunt-noise from the front suspension,
occurs more in cold ambient t ...
AGM Battery Installation
1.
Install in the reverse order of removal.
When installing the battery, ...
Front Seat Shield Outer Cover Component Location
1. Front seat shield outer cover
...