1. |
Turn ignition switch OFF.
|
2. |
Disconnect the Solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
(Refer to 35R Clutch Control Solenoid Valve - "Specifications")
|
Multimedia Jack Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly&quo ...
Control Cable Components
1. Shift lever knob
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...