1. |
Turn ignition switch OFF.
|
2. |
Disconnect the Solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
(Refer to Underdrive Brake Control Solenoid Valve - "Specifications")
|
Power Outside Mirror Switch Circuit configuration
...
Heater & A/C Control Unit (Manual) Replacement
1.
Remove the audio unit.
(Refer to Body Electrical System - "Audio Unit")
2.
After loosening the mounting screws, remove the ...
Output Speed Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...