1. |
Turn ignition switch OFF.
|
2. |
Disconnect the Solenoid valve connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
(Refer to SS-B Solenoid Valve - "Specifications")
|
Rear Glass Defogger Printed Heater Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure on th ...
Installation
WCS(Weight Classification System) is utilizing a robust weight
measuring technology. Thus, if any of the following condi ...
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, or the airba ...